Worth Data LZ404-RF Instrukcja Konfiguracji Pobierz pdf (Strona 13)

Note: If you are using the 2D 520-RF then refer to the 2D setup chart starting on page 24.

Code 3 of 9 (Code 39)

Enable Code 39

Disable Code 39

Enable Full ASCII Code 39

Disable Full ASCII Code 39

Enable Code 39 Accumulate Mode

Disable Code 39 Accumulate Mode

Enable Start/stop character transmission

Disable Start/Stop character transmission

Enable Mod 43 Check Digit

Disable Mod 43 Check Digit

Enable Check Digit Transmission

Disable Check Digit Transmission

Caps Lock ON

Caps Lock OFF

See page 20 for information about Accumulate Mode (this setting also controls Code 93 and Code 128).

Enabling Start/Stop character transmission means that the RF Laser Reader will transmit the * Start/Stop

characters to your computer along with the data. For example, data of 1234 would be transmitted as *1234*.

Enabling the Mod 43 Check Digit requires the units position of your data to match the calculation for the

check digit explained in Appendix C.

If you've enabled the check digit, enabling Check Digit transmission causes the reader to transmit it to your

computer along with the bar code data.

"Caps Lock ON" means that for all codes lower case letters read as data will be transmitted as upper case,

and upper case as lower. Numbers, punctuation & control characters are not affected. This applies to Code

128 and Code 93 also.

"Caps Lock OFF" means that letters will be transmitted exactly as read.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 72 73

Brak uwag

Worth Data LZ404-RF Instrukcja Konfiguracji Strona 13